Availability: In stock




mX-LPC1114-S is a CORTEX-M0 based stamp board for NGX’s mbed-Xpresso Baseboard. The LPC1114 microcontroller has 32KB of internal flash and 8KB SRAM. The LPC1114 operate at CPU frequencies of up to 50MHz. In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Programmable WatchDog Timer (WDT). 1 x  UART,1 x I2C-bus interfaces Fast-mode Plus with a data rate of 1 Mbit/s. 1 x SSP controllers, 8-channel 10-bit ADC, Four general purpose counter/timers with a total of four capture inputs and 13 match outputs. Integrated PMU, power on Reset and up to 42 general purpose I/O pins. GPIO pins can be used as edge and level sensitive interrupt sources.

Following are the salient features of the board:

  • Dimensions: 126x35 mm2
  • Two layer PCB (FR-4 material)
  • Onboard Test Led
  • 12MHz crystal
  • Onboard debugger.
  • No power supply required, powered by USB

Kit Contents

  • mX-LPC1114-S
  • USB Mini B-Type cable

User Manual
Sample code  --- Binaries

What tools to use?
Our products are in general not tied up to one particular tool. All the tools that support lpc11xx cortex-M0 series of microcontrollers can be used, to name a few:

How to program the board?
There are various options:

  • SWD: Programming through SWD using CooCox CoFlash and debugging using CooCox CoIDE.To use, install USB driver software ColinkExUsbDriver
  • ISP: Programming through the on-chip bootloader using UART interface and  FlashMagic