Availability: In stock




mX-LPC1343-S is a CORTEX-M3 based stamp board for NGX’s mbed-Xpresso Baseboard. The LPC1343 microcontroller has 32KB of internal flash and 8KB SRAM. In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software.Programmable WatchDog Timer (WDT). 1 x  UART,1 x I2C-bus interfaces Fast-mode Plus with a data rate of 1 Mbit/s. 1 x SSP controllers, 8-channel 10-bit ADC, USB 2.0 full-speed device controller with on-chip PHY for device,motor control PWM, Four general purpose counter/timers with a total of four capture inputs and 13 match outputs. And up to 42 general purpose I/O pins.GPIO pins can be used as edge and level sensitive interrupt sources.

Following are the salient features of the board:

  • Dimensions: 126x35 mm2
  • Two layer PCB (FR-4 material)
  • Onboard Test Led
  • 12MHz crystal
  • Onboard debugger.
  • No power supply required, powered by USB

Kit Contents

  • mX-LPC1343-S
  • USB Mini B-Type Cable

User Manual
Sample code  -- Binaries

What tools to use?
Our products are in general not tied up to one particular tool. All the tools that support lpc13xx cortex-M3 series of microcontrollers can be used, to name a few:

How to program the board?
There are various options: